This category contains all of our posts that is on configuration of network.
In this article, we will explore the process of setting up static NAT on a Cisco router. Network Address Translation (NAT) is a algorithm that maps private IP addresses with public IP addresses, facilitating internet routing. There are two primary types of IP addresses: IPV6 and IPV4. Initially, IPV4 served as the primary IP addressing […]
How To Configure Static NAT on Cisco Router In Packet Tracer Read More »
Layer 3 switches, commonly known as multilayer switches, possess the capability to perform both routing and switching functions. While these switches can inherently handle switching, we need to enable IP routing on their interface for them to be able to handle packet routing. In this post, I will show you how to configure EIGRP on
How To Configure EIGRP on a Layer 3 Switch in Packet Tracer Read More »
A Multilayer switch, also referred to as a Layer 3 switch, is a type of switch with the capability to perform both routing and switching functions. By default, a Multilayer switch can implement packet switching. However, for the Layer 3 switch to carry out routing functions, we need to enable IP routing from its global
How to Configure RIP on Layer 3 Switch in Packet Tracer Read More »
A Switch Virtual Interface (SVI) is a virtual interface configured on the Layer 3 switch to act as the interface used by all host devices connected to the Layer 3 switch for transmitting their traffic to other subnetworks. The SVI in Layer 3 switches is equivalent to a router interface, where an IP address is
How To Configure SVI On Layer 3 Switch in Packet Tracer Read More »
Access Control Lists (ACLs) play a pivotal role in network security, facilitating the management of traffic flow within a network. The configuration of ACLs allows for the specification of permissions of traffic to subnetwork or individual host devices, such as servers. To create an ACL, one must define permissions (rules) on the router or Layer
How to Configure ACL On Layer 3 Switch in Packet Tracer Read More »
Similar to a router, a Layer 3 switch can route traffic using Layer 3 information. A layer 3 switch is a device that can perform both routing and switching functions. We simply need to enable IP routing on the switch interface when we want to use it for routing purposes. It performs switching by default.
How To Configure Static Route On Cisco Layer 3 Switch in Packet Tracer Read More »
Any basic network will definitely consist of a router, switch, and PC, so as a networking student, you need to learn how to configure router switch and PC in packet tracer. A router is a network device that responsible to routing traffic to other host devices in the network or to the internet. A switch
How To Configure Router Switch And PC In Packet Tracer Read More »
If you are new to using packet tracer, you might find it very hard to do some of the basic things like connecting a PC to a router, connecting a switch to a router, or connecting a PC to a switch. Though you might find the location of these devices (as they are closely positioned),
How to Connect PC To Router In Cisco Packet Tracer Read More »
Connecting and configuring three routers in Packet Tracer can be a complex task, especially if you are not familiar with static route configuration. Additionally, when attempting to connect more than two devices to router, such as switches and/or other routers, you may encounter challenges because routers typically have two interfaces (g0/0 and g0/1) available for
How To Configure 3 Routers In Packet Tracer Read More »
Looking for How to connect two LANs in Packet Tracer? In this guide, I will show you various ways to do that. A local area network is a network used to interconnect host devices exiting a particular building or different buildings that is closely positioned. A local area network normally consists of one router, switches,
How to Connect Two LANs in Packet Tracer Read More »
