Dynamic Host Configuration Protocol (DHCP) is a protocol that dynamically assigns IP addresses to any host devices in a network from a pool of IP addresses configured on the DHCP server. Although DHCP is traditionally configured on a router or on a dedicated server, a Layer 3 switch can also serve as a DHCP server.
How to Configure DHCP on Layer 3 Switch In Packet Tracer Read More »
Network Address Translation (NAT) comprises three main types, with static NAT and dynamic NAT being two of them. Static NAT is a form of address translation that establishes a permanent one-to-one mapping between an inside local IP address (private IP address) and an inside global IP address (public IP address). This mapping enables the private
Dynamic NAT vs. Static NAT: Comparison and Differences Read More »
This article will guide you on how to Configure Dynamic NAT on Cisco Router using Packet Tracer. Network Address Translation (NAT) is a crucial algorithm utilized to map private IP addresses to public IP addresses, enabling routing over the internet. Due to the substantial increase in the number of internet users over the past few
How To Configure Dynamic NAT on Cisco Router In Packet Tracer Read More »
In this article, we will explore the process of setting up static NAT on a Cisco router. Network Address Translation (NAT) is a algorithm that maps private IP addresses with public IP addresses, facilitating internet routing. There are two primary types of IP addresses: IPV6 and IPV4. Initially, IPV4 served as the primary IP addressing
How To Configure Static NAT on Cisco Router In Packet Tracer Read More »
Layer 3 switches, commonly known as multilayer switches, possess the capability to perform both routing and switching functions. While these switches can inherently handle switching, we need to enable IP routing on their interface for them to be able to handle packet routing. In this post, I will show you how to configure EIGRP on
How To Configure EIGRP on a Layer 3 Switch in Packet Tracer Read More »
A Multilayer switch, also referred to as a Layer 3 switch, is a type of switch with the capability to perform both routing and switching functions. By default, a Multilayer switch can implement packet switching. However, for the Layer 3 switch to carry out routing functions, we need to enable IP routing from its global
How to Configure RIP on Layer 3 Switch in Packet Tracer Read More »
A Switch Virtual Interface (SVI) is a virtual interface configured on the Layer 3 switch to act as the interface used by all host devices connected to the Layer 3 switch for transmitting their traffic to other subnetworks. The SVI in Layer 3 switches is equivalent to a router interface, where an IP address is
How To Configure SVI On Layer 3 Switch in Packet Tracer Read More »
Access Control Lists (ACLs) play a pivotal role in network security, facilitating the management of traffic flow within a network. The configuration of ACLs allows for the specification of permissions of traffic to subnetwork or individual host devices, such as servers. To create an ACL, one must define permissions (rules) on the router or Layer
How to Configure ACL On Layer 3 Switch in Packet Tracer Read More »
Layer 3 switch, often referred to as multilayer switch, are switches that perform both routing and switching functions. By default, layer 3 switches can perform switching functions; however, for a layer 3 switch to perform routing functions, we need to enable IP routing on the switch interfaces from global configuration mode. In our previous post,
How To Configure OSPF on Layer 3 Switch In Packet Tracer Read More »
Similar to a router, a Layer 3 switch can route traffic using Layer 3 information. A layer 3 switch is a device that can perform both routing and switching functions. We simply need to enable IP routing on the switch interface when we want to use it for routing purposes. It performs switching by default.
How To Configure Static Route On Cisco Layer 3 Switch in Packet Tracer Read More »
