How to Power on IP Phone in Packet Tracer

Unless the IP phone is powered on, you won’t be able to configure it or access the graphics user interface. In this post, I will show you how you can power on the IP phone so that you will be able to configure it and test your configuration. I will provide a video that will show you how to do that and then work you through a step-by-step guide on how you can do that.

Here is a short  video  showing how to power on IP phone in packet tracer;

How to Power on IP Phone in Packet Tracer (steps)

Here are steps to power on IP phone in packet tracer;

Step 1: Launch the Physical tab

Double tap on the IP phone to launch the physical tab as shown below;

ALSO READ:  Everything About Multiprotocol Label Switching (MPLS)

ip phone physical tab

Step 2: Power on the IP phone

After launching the physical tab, you can power on the phone by dragging the IP phone Power adapter and dropping at the power port.

dropping the ip phone power adapter

That is all you need to do in other to power on the IP phone. Here is a video tutorial on how to complete the above steps;

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top